crwdns2933803:07crwdne2933803:0
crwdns2933797:0Murathan Arazcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Murathan Araz
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* green] Place the belt idler pulley in its place. |
|---|---|
| + | [* yellow] Use [http://zaribo.org/screws-nuts/67-zaribo-screw-kit.html|M3x20 Socket Cap Screw] and M3 nut to fix the idle pulley. Do not too tighten, idle pulley should turn freely. |
| + | [* light_blue] Mount 2x [http://zaribo.org/screws-nuts/67-zaribo-screw-kit.html|M3x20 Socket Cap Secrews] and 2x M3 Nuts and tighten them equally. Leave 5mm distance between the idle pulley piece and extrusion mount piece. |
| + | [* blue] Use a M6x14 Socket Cap Screw to mount the tensioner. Ensure that idler pulley and GT2 motor pulley are aligned. This is not the latest alignment, so do not final tighten. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0