crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:05crwdne2933803:0

crwdns2933797:0Naomi Fernandezcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Naomi Fernandez

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Lift up the circuit board slowly from the right and continue to raise the right side up until a noticeable tug underneath the circuit board disappears.
-[* icon_caution] Make sure the two ribbon cables underneath the circuit board come off during motion. The two ribbon cables cause the tug underneath the circuit board.
+[* black] Lift up the circuit board gently from the right. You will notice some resistance due to the two ribbon cables attached underneath the circuit board. Continue to lift gently on the right until the ribbons detach and the resistance is released.
+[* icon_caution] Proceed carefully with this step so that the cables are released without damage.