crwdns2933803:07crwdne2933803:0
crwdns2933797:0Tony Trancrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tony Tran
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] If you want to replace the ball, remove the ball. | |
| - | [* |
| + | [* red] To remove the ball, flip the circuit board over to the other side, and find the two prongs as indicated. |
| [* black] Use a precision flathead screwdriver to dislodge the prongs from the circuit board and push the prongs through the slots. The trackball should fall out from underneath. | |
| - | [* red] Insert new trackball, by guiding the prongs through the slots on the circuit board. |
| [* black] Once inside the slots, do a soft pressing motion to make sure the prongs are all the way through. | |
| [* icon_note] Check on the other side if the prongs are latched on. |