crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Naomi Fernandezcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Naomi Fernandez

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] The ball should be exposed on the other side of the circuit board.
+[* black] Flip the circuit board over to reveal the trackball.
[* black] If you want to clean the ball, use an air duster and gently spray the ball. Keep a distance of 2-4 inches between the duster and ball.
-[* icon_note] You may reassemble at this point if you are not replacing the trackball. If you are replacing the trackball, skip previous bullet and move on to Step 7.
+[* icon_note] If you are not replacing the trackball, you may reassemble at this point. If you are replacing the trackball, skip the previous bullet and move on to Step 7.