crwdns2933803:03crwdne2933803:0
crwdns2933797:0Eric Jansoncrwdnd2933797:0crwdne2933797:0
crwdns2936045:0crwdne2936045:0 crwdns2933505:0crwdne2933505:0 Ryan Lutz
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Allow the lower EMI shield to hang down from the display. | |
| [* red] Remove the four 7.5 mm T10 Torx screws securing the display to the rear case. | |
| [* icon_note] The screws are recessed, so a thin magnetic screwdriver aids in removal. Most bit drivers are too short to reach these screws. | |
| + | [* black] When reassembling (if you don't have a magnetic screwdriver) something sticky on the end of your screwdriver (like a small amount of toothpaste) helps to hold the screws on until they're in place. |