crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Matthew Quandtcrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Allow the lower EMI shield to hang down from the display.
[* red] Remove the four 7.5 mm T10 Torx screws securing the display to the rear case.
-[* icon_note] The screws are recessed, so a thin magnetic screwdriver aids in removal. Most bit drivers are too short to reach these screws.
+[* icon_note] The screws are heavily recessed (about 1" deep in the enclosure), so a thin magnetic screwdriver aids in removal. Most bit drivers are too short to reach these screws.
+[* icon_caution] When you reassemble the computer and re-insert these screws, tape them to the tip of your screwdriver to aid in the insertion process, as they tend to fall down into the case and get stuck behind the motherboard if you don't.