crwdns2933803:010crwdne2933803:0
crwdns2933797:0Justin Ogiharacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Justin Ogihara
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Reorient the brewer as shown in the picture. | |
| - | [* black] Locate the four 140mm screws holding the top frame of the Keurig in place. Remove these screws using the |
| + | [* black] Locate the four 140mm screws holding the top frame of the Keurig in place. Remove these screws using the Phillips #1 screwdriver. |
| [* red] Two of the screws are on the inside of the frame close to the water heater. | |
| [* icon_note] You may need to decrease the size of the screwdriver in order for it to fit inside the frame. Do this by taking out the bit extender. | |
| [* orange] The other two screws are located on the outside of the frame. |