crwdns2933803:024crwdne2933803:0
crwdns2933797:0Anthony Kouttroncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Anthony Kouttron
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Here's some general guidelines to follow for FEA simulations: |
|---|---|
| + | [* black] Sharp internal corners may cause inaccurate results |
| + | [* black] The finer the mesh of polygons, the greater the accuracy of your results |
| + | [* black] Minimum safety factor of 3 is recommended for designs. Shoot for 2x yield strength at least. The red zone signified the yield strength of the material has been reached and the part has failed. |
| + | [* black] Static stress studies are not ideal for materials with higher elasticity, such as rubber and plastic, |
| + | [* black] Static testing does not consider damping or inertial effects, such as momentum. |
| + | [* black] Stresses should not exceed yield-strength of material. Results would be obvious. |
| + | [* black] Load must cause deflections or rotations in the item under test. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0