crwdns2933803:016crwdne2933803:0
crwdns2933797:0Anthony Kouttroncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Anthony Kouttron
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] 6 parts were printed to serve as examples of minor design iterations of the part. This was intentional in case I made an error in measurement. Four additional prints were made as extras in case the parts were damaged during cleanup. |
|---|---|
| + | [* black] A good way to keep track of different part iterations is to engrave revision letters or numbers into the part printed. In this case, I embedded the label into the bottom of the cap where it would not be seen. |
| + | [* black] S = stepped geometry on cut 16 |
| + | [* black] W = Wider semicircle on cut 17 |
| + | [* black] N = Notched length on cut 11 |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0