crwdns2933803:015crwdne2933803:0
crwdns2933797:0Anthony Kouttroncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Anthony Kouttron
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] With the cover removed, go ahead and begin removing all the ribbon cables from the PCB. Remove the 2 pin connector as well. |
|---|---|
| + | [* black] There is one more screw holding in the PCB. Remove the screw on the left hand side of the camera which holds the I/O cover to the PCB. |
| + | [* black] The PCB should now be relatively lose inside the camera. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0