crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:010crwdne2933803:0

crwdns2933797:0Adam O'Cambcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Adam O'Camb

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Trace the two-wire temperature cable you disconnected from the old hard drive. It should end at a plug on the motherboard labeled ***HD TMP*** or ***HDD TEMP***.
-[* black] If the previous temperature cable is still connected to the plug, disconnect and remove it. You will no longer need it.
-[* black] Connect the two-wire red-black temperature cable coming from the temperature probe to the same motherboard plug.
+[* black] Find a connector on the motherboard labeled ***HD TMP*** or ***HDD TEMP***.
+[* black] If the previous temperature cable is still connected to the board here, disconnect and remove it. You will no longer need it.
+[* black] Connect the temperature sensor's two-wire red-black cable to the motherboard plug labeled ***HD TMP*** or ***HDD TEMP***.
[* icon_note] The connector is keyed to fit in one way only. If it seems like the connector is not fitting the socket, flip the connector and try again.
-[* black] Route the excess wire out of the way.
+[* black] Route the excess wire so it does not interfere with any other components.