crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Shasta Banchiocrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Shasta Banchio

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] A lot of the time when the drones crash the gimbal bushings become unattached leaving the camera configuration hanging by a few wires.
-[* black] This is fixed by putting the gimbal bushings (the squishy rubber things) back onto there plastic alignment mounts. Then the the circle that is separated from the main body of the bushing is then inserted into a hole. One above and one below for each of the four bushings.
-[* black] Getting the bushing to fit in the designated hole can be difficult. It is smart to use something skinny like a toothpick to push it into place
+[* red] Put the gimbal bushings (the squishy rubber things) back into the plastic alignment mounts.
+[* black] The circle that is separated from the main body of the bushing should then be inserted into the hole.
+[* icon_note] When pushing these bushings back into place, it is smart to use a skinny tool or toothpick.