crwdns2933803:03crwdne2933803:0
crwdns2933797:0Jarod Lylescrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jarod Lyles
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Remove the red waterproofing seal. | |
| [* black] Using a Q-tip or a microfiber cloth, clean the inside of the groove on the button and screen protector housing and the area surrounding the mother board on the band panel. Cleaning the places where the waterproofing seal comes into contact will improve the waterproofing of the watch. | |
| - | [* icon_note] If the original waterproofing seal is not damaged, then it may just need to be cleaned. To |
| + | [* icon_note] If the original waterproofing seal is not damaged, then it may just need to be cleaned. To improve the seals effectiveness, consider cleaning the seal in warm water with a mild dish soap. Air dry or lightly dry the seal with a paper towel before inserting into the button and screen protector housing. |
| [* black] Place a new (or cleaned) waterproofing seal into the groove that surrounds the button and screen protector housing. Make sure the seal fits snugly and entirely into the groove. No part of seal should be outside of the groove. You may need to stretch the seal to make it fit in the groove. |