crwdns2933423:0crwdne2933423:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Justin Sinichkocrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Justin Sinichko

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Assemble back of enclosure
-[* black] Start by placing the bottom (notched) into the bottom lip of the enclosure.
-[* black] Align all three mounting holes.
-[* black] Press firmly (avoid putting pressure on horse) around the edges until the back presses flush with the outside edge.
-[* black] Drive three M2 screws into place. DO NOT OVER TIGHTEN!
+[* black] Start by placing the bottom notched-side into the lip of the enclosure.
+[* black] Align all three mounting holes from above.
+[* black] Press firmly with both hands (avoid putting pressure on horse) and work your hands around the edges until the back is pressed flush.
+[* black] Secure the back of the enclosure by driving three M2 screws into place. ++DO NOT OVER TIGHTEN!++