crwdns2933803:07crwdne2933803:0
crwdns2933797:0Stefan Lewiscrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Stefan Lewis
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Reassembling the Heater - Part II |
|---|---|
| + | [* light_blue] Make sure ONLY the larger plug is connected to the Circuit Board; we will connect the smaller one later to make it easier. |
| + | [* orange] Then make sure all the Spring are lined up correctly and seated in there spots. |
| + | [* violet] Press down on the Circuit Board until the board meets the cover and the Screw Holes are aligned with one another. |
| + | [* icon_note] Make sure that the springs are still in alignment. |
| + | [* red] Then with one hand, place your screws in and tighten them. |
| + | [* icon_caution] Be sure to stop the moment they get tight you don't want to crack the board. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0