crwdns2933803:04crwdne2933803:0
crwdns2933797:0Brooke Masoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Brandon Wong
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Rewire the autosampler connections | |
| [* black] 7. Insert the wires and screw down using 260 / 1.5 x 40 flathead screwdriver until tight. | |
| [* icon_note] We do not use the green wire. | |
| [* icon_caution] Hand tight is just right. Be careful not to over-tighten and crush the wire ferrules | |
| [* orange] 8. The battery connectors go in the fifth and sixth positions from the left (orange box). | |
| + | [* blue] If the battery connectors do not have the white caps on the ends, then it will have one thick red and one thick black wire. To make it easier to connect to the board, trim half of the copper wires off of each wire, twist the remaining wires together, put in place, and tighten screws. |