crwdns2933803:010crwdne2933803:0
crwdns2933797:0jsharriscrwdnd2933797:0crwdne2933797:0
crwdns2936045:0crwdne2936045:0 crwdns2933505:0crwdne2933505:0 Geoff Wacker
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Remove the following screws securing the logic board to the rear case: | |
| [* red] Two 2.3 mm Phillips screws | |
| [* orange] Two 2.7 mm standoff screws. | |
| - | [* icon_note] These screws have a Phillips bit pattern, but we found the best removal tool to be a 2.5 mm flathead driver. |
| + | [* icon_note] These screws have a Phillips bit pattern, but we found the best removal tool to be a 2.5 mm flathead driver. They are not phillips screws, the center hole is threaded. |
| [* yellow] One non-magnetic 2.7 mm standoff screw | |
| [* icon_note] Be sure to put this screw back in its original position at the top of the logic board. A magnetized screw may interfere with the digital compass. | |
| [* icon_reminder] Reassembly hint: when putting the standoffs back in, use the tip of a spudger like a screwdriver to get them started. |