crwdns2933803:010crwdne2933803:0
crwdns2933797:0Kyle Jurickcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Andrew Optimus Goldheart
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Remove the following screws securing the logic board to the rear case: | |
| [* red] Two 2.3 mm Phillips screws | |
| [* orange] Three 2.7 mm standoff screws | |
| [* icon_note] These screws have a Phillips bit pattern, but we found the best removal tool to be a 2.5 mm flathead driver. | |
| + | [* black] When you put the standoffs back in, you can easily get them started by inserting the tip of the spudger into the female threads |