crwdns2933803:07crwdne2933803:0
crwdns2933797:0Jeff Suovanencrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jeff Suovanen
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] First item on the menu: the dual microphone cable near the bottom of the face plate. |
|---|---|
| - | [* black] Moving right along we snag the faceplate-mounted mainboard, saving the secondary I/O board for later |
| - | [* black] Peeling that board up we find a hefty copper plate, likely used to keep things cool. Passive cooling will be the way to go, to keep this device light enough to wear on your face! |
| + | [* black] First component on the menu: the dual microphone assembly near the bottom of the face plate. |
| + | [* black] Here we encounter a spot of tough glue, and it takes some heat and a bit of careful spudgering to remove it cleanly. Fortunately, there's no reason to do this unless you're replacing the mics, so the risk of collateral damage is low. |
| + | [* black] Next we snag the faceplate-mounted mainboard, which wrangles signals from the IR sensor arrays, cameras, and microphones. |
| + | [* black] Beneath the board, we find a hefty slab of copper foil, likely used to keep things cool. Passive cooling will be the way to go, to keep this device light enough to wear on your face! |
| [* black] And under ''that'' we find the cameras! Two separate units with no identifiable markings. |