crwdns2933803:03crwdne2933803:0
crwdns2933797:0jadeterscrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 jadeters
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [title] Remove keyboard |
|---|---|
| - | [* black] Using a flat screwdriver or small spudger, lift the keyboard up starting near the bottom edge. |
| - | [* black] There are two ribbon cables; the wider is for the keyboard, and the other is for the touchpoint. |
| - | [* black] Disconnect the ribbon cables by flipping up the plastic keeper holding each ribbon in place. |
| - | [* black] Note their alignment and how deeply each ribbon was inserted in its connector. This knowledge will help you when reinserting the new ribbon cables. |
| - | [* black] Remove the keyboard. |
| + | [title] Free the keyboard |
| + | [* black] Slide the keyboard toward the screen, so the function-key edge starts to slip beneath the bezel. |
| + | [* black] Using a flathead screwdriver or spudger, lift the arrow-key-edge of the keyboard until it clears the bezel above the palm rest. |
| + | [* black] Slide the keyboard away from the screen, with the arrow-key-edge still above the palm bezel. |
| + | [* black] Lift the function-key edge and expose the back of the keyboard. Adhesive on the ribbon cables may tug but will easily loosen. |