crwdns2933805:0crwdne2933805:0
crwdns2933797:0Jeff Suovanencrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jeff Suovanen
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* icon_note] The fingerprint sensor cable connects the phone to the rear glass near the main camera. The cable is very short and should disconnect as the rear glass is removed. |
|---|---|
| - | [* icon_caution] As you lift the glass, peek in to be sure the orange cable with a blue connector has disconnected. |
| - | [* black] Use the opening picks to slice through any remaining adhesive and open the phone slightly. |
| - | [* icon_caution] If the fingerprint sensor cable seems snagged or stays taut do not open the phone any further. Use the tip of a spudger to lift the connector and disconnect the sensor cable before proceeding. |
| - | [* black] Remove the glass from the phone. |
| + | [* icon_note] The fingerprint sensor, which is embedded in the back cover, connects to the motherboard by way of a short flex cable. |
| + | [* icon_caution] Slowly lift the back cover from the left edge (as viewed from the back) and make sure the fingerprint sensor flex cable disconnects safely. |
| + | [* black] If not, use the point of a spudger to disconnect the cable by prying its connector straight up from the motherboard. |