crwdns2933805:0crwdne2933805:0
crwdns2933797:0Cedric Bossacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Cedric Bossa
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Next we have to remove the wires connecting the head and leg sections. We will disconnect all of the wire connections in this step and they will need to be re-connected at the end, so be careful when disconnecting. | |
| - | [* black] Now that the wires have been disconnected, the head and back legs should be free to place asid |
| + | [* black] Now that the wires have been disconnected, the head and back legs should be free to place aside |
| + | [* black] To get to the sensors, you must detach the motherboard. To do so, take out the two clips keeping the motherboard in place but applying upwards pressure on them. |
| + | [* black] After the motherboard is taken out, the sensors are underneath. You are free to remove the sensors and replace them with new ones. |