crwdns2933803:01crwdne2933803:0
crwdns2933797:0Terrycrwdnd2933797:0crwdne2933797:0
crwdns2936045:0crwdne2936045:0 crwdns2933505:0crwdne2933505:0 101 Tech USA
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] The first step to re-assembling the gearbox is to make sure the wiring is in the right place. Check the switch itself is in position and screwed down. | |
| [* black] If the AEG is wired to the rear then it should look like it does in the first picture. | |
| [* yellow] Check to see if the switch spring is attached to the post on the gearbox and the trigger plunger. | |
| [* green] Make sure the red wire going across the area circled is on the bottom. | |
| [* icon_caution] Warning: If the wire going across is on the top it will make contact with the motor's gear stripping the wire and creating a electrical short. | |
| [* violet] Now you can add the trigger make sure the spring that fits on the trigger is attached. Without that spring the trigger will not be able to reset after a shot on semi-auto. | |
| + | [* black] 12312ij190u9jdfjsjfoj sjdfjklkjf |