crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Blake Kleincrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Blake Klein

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Unpin four (4) ribbon cables under the battery by pulling up on the small plastic tab at its head.
-[* black] Pull out the ribbon cables by pulling out the pieces of plastic tape that are sticking out.
-[* orange] Pull out the power connector shown.
+[* red] Use a spudger to flip up the black latch on the four ZIF connectors.
+[* black] Remove the four ribbon cables from the ZIF connectors.
+[* orange] Disconnect the speaker from the board.