crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Matthew Suttoncrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Matthew Sutton

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Next we have to remove the wires connecting the head and leg sections. We will disconnect all of the wire connections in this step and they will need to be re-connected at the end, so be careful when disconnecting.
-[* black] Now that the wires have been disconnected, the head and back legs should be free to place aside.
-[* black] If you are replacing the speaker or sensors in your Zoomer Show Pony, skip the next two bullet points.
+[* black] Remove the wires connecting the head and leg sections. We will disconnect all of the wire connections in this step and they will need to be re-connected at the end, so be careful when disconnecting.
+[* black] Place the head and back legs to the side when they are completely disconnected.
+[* black] If you are not replacing the volume/power slider in your Zoomer Show Pony, skip the next two bullet points.
[* black] To replace the power/volume switch, you will need to remove the screws marked in orange. These screws are the first Phillips head screws in the pony, so you will need to keep these separate from the other screws you've removed.
[* black] With the screws removed, you are free to lift out the switch and replace with a new one.