crwdns2933805:0crwdne2933805:0
crwdns2933797:0Marcus Glowacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Marcus Glowa
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Rotate the unit right side up. | |
| [* black] Remove the black protective material using the 8.0 cm plastic opening tool to gain access to the four 9.0 cm control panel access screws and six 9.0 cm processing board access screws. | |
| [* black] Using the t8 bit and driver, remove the four 9.0 cm control panel board access screws. | |
| [* icon_caution] There is a ZIP connection underneath the protective cover with limited length. | |
| [* black] With the front of the unit facing you, lift the control panel protective cover up using your thumbs as leverage. | |
| - | [* |
| + | [* red] Using the spudger, slide the flat end underneath the ZIP connector plastic flap to release the ribbon cable from the control panel. |