crwdns2933805:0crwdne2933805:0
crwdns2933797:0Gary Mcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Taylor Dixon
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] next, remove the antenna bar. unlike the previous generation MacBook pros, the wifi antenna is not attached to the display assembly. | |
| [* black] To remove the antenna bar, start by removing the 12 screws located above the left/right heat sink vents by using a Pentalobe-2 (P2) bit. | |
| - | [* black] next, remove the shield plates by taking out the 8 screws circled in green. |
| + | [* black] next, remove the shield plates by taking out the 8 T3 screws circled in green. |
| [* black] after the shields are removed, lift up on the center snap-in connector on the antenna bar. |