crwdns2933805:0crwdne2933805:0
crwdns2933797:0Adam O'Cambcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Adam O'Camb
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Peel off the four black tamper-evident stickers covering the heat sink mounting screws. |
|---|---|
| + | [* red] Remove the four T10 screws that secure the heat sink from the backside of the logic board. |
| + | [* icon_reminder] During reassembly, tighten these screws one full turn at a time, [https://d3nevzfk7ii3be.cloudfront.net/igi/Mkb4dN2AH1AGwe3F|alternating in a cross pattern|new_window=true]. This will gradually increase the clamping pressure evenly across the surface of the CPU. Continue gradually tightening the screws until they're snug and the entire spring plate [https://d3nevzfk7ii3be.cloudfront.net/igi/1NED52iMbNDN3NUF|lays flat|new_window=true] against the logic board. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0