crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933805:0crwdne2933805:0

crwdns2933797:0Danielle Taylorcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Danielle Taylor

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Identify the ribbon cable, located at the bottom right of the phone.
+[* red] Identify ribbon connector at the top right of the phone.
[* black] Pry the locking bar up gently with a plastic opening tool.
[* black] Remove the ribbon wires by pulling them out of the connector with a tweezer.
[* icon_note] The locking bar is the small black bar located on the digitizer’s ZIF connector.
[* icon_reminder] Be sure to push the locking bar back down using a spudger after you put the ribbon wire back in since the lock does not lock automatically.