crwdns2933803:05crwdne2933803:0
crwdns2933797:0David42crwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David42
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Remove the main circuit board | |
| [* red] Remove these 3 silver 6mm Philips #2 screws from the main circuit board. | |
| [* violet] Remove these 2 silver 8mm Philips #1 screws and their white plastic washers then unplug the ribbon cable. This plug will drop through the hole in the board when we lift off the board. | |
| [* orange] Remove these 5 silver 8mm Philips #2 screws from the main circuit board. | |
| - | [* green] Unplug this wire from the small circuit board. Peel back the two pieces of tape holding down the wire, leaving one end of each piece of tape attached to the board for the later re-assembly |
| [* black] Remove the other plug from this small circuit board. | |
| [* light_blue] unplug these 7 plugs. | |
| [* blue] Remove this larger plug by squeezing the two ends to release the clips |