crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Jeremy Taylorcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jeremy Taylor

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Find the indented groove on the left side of the device and place your fingers here.
-[* black] Pull toward you to allow the front door to drop down.
-[* icon_note] This will give you access to the two T8 TORX screws that need to be removed to release the panel
+[* black] Place your fingers on the indented groove on the left side of the printer.
+[* black] Pull toward you lightly to release the front door, allowing it to drop down.
+[* icon_note] This will give you access to the two T9-TORX 13mm screws that need to be removed to release the panel