crwdns2933803:01crwdne2933803:0
crwdns2933797:0iRobotcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 iRobot
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* icon_note] If your replacement display did not come with pre-installed speaker grilles or a front-facing camera bracket, carefully remove these parts from your old display. Follow the rest of the guide to install them on a new display. | |
| [* black] To remove the camera bracket, apply heat, then use a thin metal blade to pry the bracket away from the old screen. | |
| - | [* black] [https://d3nevzfk7ii3be.cloudfront.net/igi/6wiDS1iavbCWpVgq.full|There are two layers that make up the speaker grille|new_window=true]—the metal mesh grille, and a layer of thin fabric mesh behind it. Use tweezers to peel both layers off of the old screen together. Do your best to not separate those layers at all. |
| + | [* black] [https://d3nevzfk7ii3be.cloudfront.net/igi/6wiDS1iavbCWpVgq.full|There are two layers that make up the speaker grille|new_window=true]—the metal mesh grille, and a layer of thin fabric mesh behind it. Use [product|IF145-020|tweezers] to peel both layers off of the old screen together. Do your best to not separate those layers at all. |
| [* icon_note] Make sure to install the grilles and gasket before applying display adhesive. | |
| [* black] Cut two [guide|113604|corners of a pre-cut adhesive card|stepid=217050|new_window=true] so that each side is no more than 12 mm (0.5 inches) long, or cut four 12 mm (0.5 inches) strips of double-sided adhesive. | |
| [* icon_note] The adhesive strips should be no wider than 1 mm. | |
| [* black] Apply the adhesive strips to the edges of the flat side of the front-facing camera bracket. When you're done, there should be adhesive on all four edges of the camera bracket. | |
| [* black] Gently press the adhesive into place using your finger or a spudger. |