crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Elizabeth Sadewassercrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Elizabeth Sadewasser

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Remove the four screws securing the keyboard using the Philips #1 screwdriver .
-[* orange] Detach the ribbon cables carefully using the spudger to gently pry up on the clip until it releases the ribbon cable or lift up on the blue tab gently until the clip releases the ribbon cable.
-[* yellow] Pry the black, red, and white wire connector apart using the spudger to separate it.
+[* red] Remove the four (mm) screws securing the keyboard using the Philips #1 screwdriver .
+[* orange] Detach the ribbon cable carefully using the spudger to gently pry up on the clip until it releases the ribbon cable or lift up on the blue tab gently until the clip releases the ribbon cable.
+[* yellow] Disconnect the wire connector by using the flat end of spudger to gently pry it apart from the connection point; this can also be accomplished by holding the connector and gently wiggling the connector loose.