crwdns2933803:01crwdne2933803:0
crwdns2933797:0Jonathan Bowyercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jonathan Bowyer
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Desolder the red LED wires from the solder pads near the rotating head of the device. These wires are quite delicate, so be sure the solder is fully melted before attempting to pull the wire out. |
|---|---|
| + | [* black] Use a pair of tweezers to remove the plastic housing and the LED from the device. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0