crwdns2933803:02crwdne2933803:0
crwdns2933797:0Markcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Mark
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* red] Locate the 5 captive screws that hold down the heat sink assembly to the central processing unit and the graphics processing unit. |
|---|---|
| - | [* icon_note] The captive screws are marked 1-5 in consecutive order. |
| + | [* red] Locate the (5) captive screws that hold down the heat sink assembly to the central processing unit and the graphics processing unit. |
| + | [* icon_note] The captive screws are marked 1-5 in consecutive order, and they will not come off of the heat sink when loosened. |
| [* black] Unscrew captive screw #1 with a J1 Phillips screwdriver for one or two turns and move onto the next screw (#2) and so on, in consecutive order. | |
| - | [* black] Continue to slowly loop around the 5 captive screws in order, only loosening the screws one or two turns each |
| - | [* icon_caution] Do not loosen any captive screw fully without |
| + | [* black] Continue to slowly loop around the 5 captive screws in order, only loosening the screws one or two turns each time until all screws are completely retracted. |
| + | [* icon_caution] Do not loosen any captive screw fully without moving to the other screws first! This can bend the heat sink assembly and possibly damage the processors. |