crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2944351:0crwdnd2944351:0How to tighten the belts on a ProtoCentre 999crwdnd2944351:0crwdne2944351:0

crwdns2933797:0abhishek jcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 abhishek j

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0
crwdns2866306:0crwdne2866306:0
AHA 3D
Type
replacement
Thing
Belt tightening
Title
BELT TIGHTNING
Introduction
Belts are used for transfer of motion, but they might lengthen or loosen after continuous operation. The belt must be tight else you will feel the print corners being shaky and not in line.

Check that the belt is tight every fortnight (15 days of operation). For tightening the belt follow this procedure.
Time Required Min
crwdns2931273:0crwdne2931273:0
Time Required Max
crwdns2931273:0crwdne2931273:0
Objectid

crwdns2933769:0crwdne2933769:0

crwdns2933771:0crwdne2933771:0
Difficulty
Moderate
Conclusion
To reassemble your device, follow these instructions in reverse order.
Author
abhishek j
Public
crwdns2853046:0crwdne2853046:0

crwdns2935255:0crwdne2935255:0

  • In Progress added.
  • Community-Contributed Guide added.

crwdns2933623:0crwdne2933623:0

crwdns2933815:01crwdne2933815:0
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
stepid 176439 stepid 176439
crwdns2933815:02crwdne2933815:0
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
stepid 176440 stepid 176440
crwdns2933815:03crwdne2933815:0
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
stepid 176441 stepid 176441