Introduction |
If your Canary does not light up, this guide will show you how to replace the Infrared LED board. | | Remove the power connector from the LED board. Flip the board over and disconnect the power connector to the left of the buzzer (labelled "IR-LED MIC"). Then the heat sink can be removed, by removing the four screws holding together the frame. | Before you unscrew anything, there are two power connectors you must disconnect. As always, do not pull on the wires of the power connector. | | Use extra care when removing the board as these wires are easily damaged and will require resoldering. Treat the wires carefully. | The four screws for the heatsink also hold the infrared LED board in, so grab onto it to prevent it from falling. There is another set of screws on the board for the LED frame; you do not need to remove these. | | A Phillips #0 screwdriver can be used for all four screws. |
|