| A guide for replacing the back panel on the G3 Gamecube Controller by Gamestop. |
| A guide for replacing the back panel on the G3 Gamecube Controller by Gamestop. The steps to get to the final replacement are too short and simple. The pictures display points of interest using circles, however, it is hard to see which part is being circled. The details in explaining each step just get to the point, there is not detail in how to find or spot the point of interest. |
|
|
|
| Step 1: Removing the back panel screws |
|
| There are a lot of small wires inside the controller which means when removing the back panel it must be a slow and careful step. There are no details in there for this. |
|
|
|
| Step 2: Rumple motor |
|
| This needs to be expanded on due to the amount of pictures there are, and how little text there is to support those pictures. No one knows what a rumble motor is, so there should be steps in identifying it, and each subject in the pictures. |
|
|
|
| Step 3: Taking off entire back panel |
|
| Similar to step 2. More pictures than text. There needs to be text that explain what they are doing in each picture. Also, this should be a step that introduces how to replace it and put it back together. The guide is too short and simple to easily follow and complete. |