|
Introduction |
If your Vtech InnoTab 3s is not functioning properly, or your device show’s no signs of turning on, this guide will give you the information on how to properly remove the motherboard from the device. | | WARNING: Before you start any type of disassembly process on your Vtech InnoTab 3s, make sure it is turned off otherwise, you will cause further damage to your device. | | The motherboard, like on all other electronic devices, is considered the '“Brains” of the device; all data inputs and outputs are controlled and operated by the motherboard, and what ultimately creates any piece of technology. However, all is not lost if one day your Vtech InnoTab 3s motherboard decides to die on you one day. Replacing it is fairly straight forward and ultimately is cost efficient. | | If your Vtech InnoTab 3s is not functioning properly or shows no signs of turning on, this guide will give you information on how to safely remove the motherboard from the device. Resolving this issue with our few simple steps will ensure that all data from this device will be saved. | | Before you start the disassembly process, make sure your device is completely shut off as working on a device that is on can further damage the motherboard. | | No special skills are required. However, you will need a spudger and sizes 5,6, and 7 mm screwdrivers to open up the back of the device where the motherboard is located. These are the six screws that will secure the motherboard to the front panel of the device. |
|