crwdns2944351:0crwdnd2944351:0Monroe KA Teardowncrwdnd2944351:0crwdne2944351:0
crwdns2933797:0Colton Normancrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Colton Norman
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2943215:0crwdne2943215:0
- Press-to-close Bag (Many) x1 For keeping parts safe and separated. added.
- 6-in-1 Screwdriver (Some), various sizes x1 You'll use sizes from 1/8" (3 mm) to 3/8" (10 mm). added.
- Large Needle Nose Pliers x1 The smaller the better. added.
- Probe and Pick Set x1 For poking and prying at those tricksy little parts. added.
- Penetrating Lubricant x1 Useful for separating rusted parts. Don't use WD-40, though, it doesn't work as well. added.
- 54 Bit Driver Kit 1.2mm Flathead x1 added.
- Tweezers x1 added.
- Cleaning rags (A bunch) x1 added.
- Digital Caliper x1 For measuring screws. added.
- Arbor Press x1 To press out taper pins added.
- Heat Gun x1 To heat up parts connected with taper pins added.
- Pin Punch 1/16", flat x2 Used for tapping out taper pins. It's always best to have two, in case one bends. added.
- Hammer x1 For hitting the pin punch added.
- End mill 1/16" x1 For drilling out taper pins if you have to added.