crwdns2866306:0crwdne2866306:0 |
|
Type |
|
Thing |
|
Title |
Canon EOS Rebel T2i Main PCB Board Replacement |
|
Introduction |
This guide shows you how to remove the main PCB board in the camera. This is useful in the event that the main PCB board is damaged and needs to be replaced, or if you need to access other parts such as the SD card board, or the imaging sensor. | | When you install the new main PCB board and are reconnecting the cables, note the single round black cable that leads to the top cover. This cable connects to the right side of the board and the connector is attached to the back of the board. To reconnect it, you simply need to push the cable down into the hole on the connector. | | This cable is a fiber optics cable used for the camera flash. Forgetting to reconnect this cable will likely cause the camera flash to no longer function. |
|
Time Required Min |
crwdns2931287:030crwdne2931287:0
|
Time Required Max |
crwdns2931287:030crwdne2931287:0
|
Difficulty |
Moderate
|
Conclusion |
To reassemble your device, follow these instructions in reverse order. |
|
Author |
|
Public |
crwdns2853046:0crwdne2853046:0
|
crwdns2933809:0crwdne2933809:0
crwdns2943215:0crwdne2943215:0
- JIS #00 Screwdriver x1 added.
- 1 x Opening Picks x1 added.
- Spudger x1 added.
- Angled Tweezers x1 added.
- Flathead 3/32" or 2.5 mm Screwdriver x1 added.
- Flathead 3 mm Screwdriver x1 added.
crwdns2935255:0crwdne2935255:0
- In Progress added.
- Community-Contributed Guide added.
crwdns2916646:0crwdne2916646:0
- crwdns2933785:0Parts Catalogcrwdne2933785:0
crwdns2933623:0crwdne2933623:0
crwdns2933815:01crwdne2933815:0