crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2944351:0crwdnd2944351:0Skill 7510 Belt Sander Techniquecrwdnd2944351:0crwdne2944351:0

crwdns2933797:0tcagle53crwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 tcagle53

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0
crwdns2866306:0crwdne2866306:0
Skill 7510 Belt Sander
Type
technique
Title
Skill 7510 Belt Sander Technique
Introduction
Repair sticking commutater brushes on motor. If device get left in a place where condensation can occur of if it has been left outside moisture can cause corrosion in the brush holders which can result in the following symptom... Switch on lights up the pressure LEDs on the top of the unit but the motor will not run. Banging it lightly with a dead blow hammer on the sanding plate may allow it to run some more but it will eventually stop working again. The only solution is to remove the affected brush holder(s) and clean them thoroughly so the brush move freely again.
Time Required Min
crwdns2931273:0crwdne2931273:0
Time Required Max
crwdns2931273:0crwdne2931273:0
Imageid
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
Difficulty
Moderate
Conclusion
To reassemble your device, follow these instructions in reverse order.
Author
tcagle53
Public
crwdns2853046:0crwdne2853046:0

crwdns2935255:0crwdne2935255:0

  • In Progress added.
  • Community-Contributed Guide added.

crwdns2933623:0crwdne2933623:0

crwdns2933815:01crwdne2933815:0
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
stepid 378744 stepid 378744