crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2944351:0crwdnd2944351:0Abask J05 Battery Replacementcrwdnd2944351:0crwdne2944351:0

crwdns2933797:0Mitchell Averillcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Mitchell Averill

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0
Introduction
This is a step-by-step guide to replace the internal battery of your Aback J05 dashcam.
The battery is a 200mAh polymer lithium battery that can hold a small charge in order to ensure that videos are saved in the event of a power disconnect. In the event that your videos are not being properly saved, your battery may be in need of replacement. Before you replace your battery, be sure to check the [[Abask J05 Troubleshooting|troubleshooting guide|new_window=true]], as your problem might not warrant replacement.
Note: This guide requires the use of a soldering iron and the iOpener tool. Be sure to read the [[Topic:Soldering|Soldering Guide|new_window=true]] and the [link|https://www.ifixit.com/Device/iOpener|iOpener Guide|new_window=true]for instructions on how to operate the devicedevices.
Conclusion
To reassemble your device, follow these instructions in reverse order. (Note: When doing the steps in reverse order, do not do [guide|168041|Step 5|stepid=351744]. Instead, place the front face of the device back on the main body before lining up the endcap, ensuring proper orientation with the SD card slot, and push in until you hear all four snap joints snap into place.)