crwdns2943229:0crwdne2943229:0crwdns2943229:0crwdne2943229:0

crwdns2944351:0crwdnd2944351:0Samsung Galaxy A22/A22 5G Screen Replacementcrwdnd2944351:0crwdne2944351:0

crwdns2933797:0Ellusioncrwdnd2933797:0Mha 15, 2023crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ellusion

: crwdns2933769:0crwdne2933769:0
: crwdns2933771:0crwdne2933771:0
: crwdns2933801:0crwdne2933801:0

Introduction

== Firstly remove the Sim card . ==

== == ==
== Then start heating the back of the phone all around the edges of the back with a heat gun and then start moving your pry card start around the edges of the phone to remove the adhesive it will take some time be patient and do it with care (mind the 2 cables in the middle of the phone don't damage them) ==

== == ==
== When you open the back start taking of the screws of the top of the phone and bottom frame (place them somewhere you won't lose them their is a total of 15 screws) ==

== == ==
== Then with a pry card remove the inner plastic frame of the phone carefully go all around the phone take of the frame be CAREFUL ==

== == ==
== Remove the wire that's connected from the phone on the inner plastic frame ==

== == ==
== Then remove the three ribbon cables ==

== == ==
== screen and battery ==

== == ==
== Remove the speaker cover ==

== == ==
== this will show the ribbon cable Wich is connected to the screen ==

Next remove your old screen with a heat gun and a pry cart

***make*** ***sure you go all around the edges clean left out adhesive and make sure the front is properly clean***

Place your new adhesive around the frame of the phone place your new screen on top of the phone ***and the ribbon cable inside the gap of the frame***

***closed it up and use Clam holders to press around the whole screen of the phone make sure it sticks in place***

Then turn the phone around place the all the ribbon cables back in place ***make sure your new screen works***

then repeat the process all the way around and close the back cover with new adhesive