|
Introduction |
| To remove the main board on the projector, the following steps must be taken. | | | Step 1 | | | * Turn the projector upside down so the bottom is facing up. | | * Remove the screws with a screwdriver. | | * | | | | | Step 2 | | | * Flip the projector right-side up and navigate to the back panel. | | * Remove the screws on the back panel with a screwdriver. | * Remove back panel
* Remove the screws on the power switchprotective panel with a screwdriver.
* Remove protective panel | | * | | | Step 3 | | | Gently pull out the orange ribbons from their white connectors on the circuit board. Make sure the ribbons don't break or snap. Use a screwdriver if necessary. | | | Step 4 | | | Remove the connectors that are holding the board to the device. | | | Proceed to remove main board | | | [br] | | [br] |
|