|
Introduction |
| # Remove the rubber gliders on the backside:[br] |
# The three gliders on the top are necessary in this step, but you will remove the bottom three later anyway so best to do all six at the same time.[br] | | | # Unscrew the three screws behind the top rubber gliders:[br] |
# In my case the glue/adhesive covered them[br] | | | # Use the iFixit toolkit / picks to open the cover[br] | | | # Remove the battery:[br] |
# Unplug and remove, It’s lightly glued on the backside[br] | | | # Unscrew the little black screw on the PCB which clamps the antenna cable[br] | | | # Unscrew the PCB:[br] |
# Three kind of big silver head screws[br] | | | # Remove the PCB[br] | | | # Unplug data cable:[br] |
# Lift the adhesive tape, then the white part / connector pulls up to release the cable[br] | | | # Remove all silver and black screws[br] | | | # The backplate cover:[br] | [br]
startStart in the left top and lift / pull very slowly until you completely remove it. It’s pretty robust, but the adhesive is very strong, so take your time on this step.[br] | | | # Unscrew all the little black screws and the remove the metal baseplate | | | | I have uploaded pictures, so please take a look at them if needed | | | Hope this helps and thanks to all the guys that helped | | | * ++Inchness++ | | * [link|https://www.ifixit.com/User/347005/Mike+Page|Mike Page|new_window=true] | | * [link|https://www.ifixit.com/User/2920528/Rafael+Munoz|Rafael Munoz|new_window=true] | | * ++[link|https://www.ifixit.com/User/3945491/Kris+Rodriguez|Kris Rodriguez|new_window=true]++ | | * [link|https://www.ifixit.com/User/4185942/Chad.Ruei|Chad.Ruei|new_window=true] |
|