|
Introduction |
1.# Remove the rubber gliders on the backside:
Only the three gliders on the top are necessary | | The three gliders on# Peel back or pierce the top are necessary in this step but you will removeplastic film covering the bottom three later anyway so best to do all six at the same time
2.screws
# Unscrew the three screws behind the top rubber gliders:
In my case the glue\adhesive covered them
3.# Use the ifixit toolkit / picks to open the cover
4.# Remove the battery:
5.# Unscrew the little black screw on the PCB which clamps the antenna cable
6.# Unscrew the PCB:
Three kind of big Two wide flat silver head screws, one small black screw
7.# Remove the PCB
8.# Unplug data cable:
9.# Remove all silver and black screws
10.# The backplate cover:
11.# Unscrew all the little black screws and the remove the metal base plate
| | I have uploaded pictures so please take a look at them if needed | | | Hope this helps and thanks to all the guys that helped | | | * ++Inchness++ | * [link|https://www.ifixit.com/User/347005/Mike+Page|Mike Page|new_window=true] | * [link|https://www.ifixit.com/User/2920528/Rafael+Munoz|Rafael Munoz|new_window=true] | * ++[link|https://www.ifixit.com/User/3945491/Kris+Rodriguez|Kris Rodriguez|new_window=true]++ | * [link|https://www.ifixit.com/User/4185942/Chad.Ruei|Chad.Ruei|new_window=true] |
|