crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2944351:0crwdnd2944351:0Huion PW100 Hover fixcrwdnd2944351:0crwdne2944351:0

crwdns2933797:0Rubbish Bearcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Rubbish Bear

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0
crwdns2866306:0crwdne2866306:0
Huion PW100 Battery free pen
Type
disassembly
Title
Huion PW100 Hover fix
Introduction
If your Huion PW100 pen dropped, there is a chance that it while it is hovering starts drawing on its own. This is caused by ether the wires on the cip disconnection of the inner pin that broke.
Time Required Min
crwdns2931287:030crwdne2931287:0
Time Required Max
crwdns2931287:030crwdne2931287:0
Imageid
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
Difficulty
Difficult
Conclusion
To reassemble your device, follow these instructions in reverse order.
Author
Rubbish Bear
Public
crwdns2853046:0crwdne2853046:0

crwdns2943215:0crwdne2943215:0

  • Soldering Iron x1 added.
  • E6000 Adhesive Glue x1 added.
  • Flathead 3/32" or 2.5 mm Screwdriver x1 2.5 mm or smaller added.
  • Toothpick x2 for glueing the inner pin added.

crwdns2935255:0crwdne2935255:0

  • In Progress added.
  • Community-Contributed Guide added.

crwdns2933623:0crwdne2933623:0

crwdns2933815:01crwdne2933815:0
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
stepid 279424 stepid 279424