|
Introduction |
| This details how to remove the (satellite) speaker terminals on the back of the Klipsch Promedia 2.1 computer speakers and replace them with new, similar, but not identical terminals. | | | How do you know if your speakers are the original version of the Promedia 2.1 model? | | | # There is a rocker-type power switch on the amp. | | # One of the satellite (small) speakers has a control pod near the bottom, [br] | | with volume and bass control on it and; | | # It says version 2.1 on the amp surface near the serial number. | | The subsitute terminals are not an exact drop-in replacement forthe original ones. The solder terminals on them are too wide to fit through the circuit board holes. However, the new terminals fit the amp opening very nicely without the circuit board. Instead of using the circuit board, we put it aside. We use some bolts and nuts to hold the new terminals directly to the amp wall. We use silicone caulking to fill any air gaps caused by imperfect fit. The results are very good. |
|