crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2944351:0crwdnd2944351:0Milwaukee Hole Hawg 1675-1 Chuck Replacementcrwdnd2944351:0crwdne2944351:0

crwdns2933797:0Rufus Baileycrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Rufus Bailey

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0
Introduction
Has your Hole Hawg lost its bite on drill bits? If so it could be worn and in need of replacement. Here is a link to the [[Milwaukee Hole Hawg 1675-1 Troubleshooting|Milwaukee Hole Hawg 1675-1 Troubleshooting page]]. The chuck has three jaws that clamp down allowing the use of multiple sizes of drill bits. Over time and had use these jaws can wear allowing the drill bit to slip or not spin at all. All you will need for this repair is a 3/16 Hex key.